Table of Contents
Advertisement
5.1 Burner overview
A. Burner cap
B. Burner crown
C. Ignition candle
D. Flame safety device
5.2 Ignition of the burner
Always light the burner
before you put on the
cookware.
WARNING!
Be very careful when you
use open fire in the kitchen
environment. The
manufacturer declines any
responsibility in case of the
flame misuse.
1. Touch
for 1 second to activate the
hob.
After 20 seconds of non-use, the hob
deactivates.
2. After light animation, when you see
on display, touch the control bar
at the correct heat setting or move
your finger along the control bar until
you reach the correct heat setting.
To set or change the heat setting.
If after some tries the burner
does not light, check if the
crown and its cap are in
correct positions and clean
the metal part of the flame
safety device (Refer to "Care
and cleaning").
If during the normal use of
the burner it starts to spark
and flame adjust
automatically, check if the
metal part of the ignition
candle and the flame safety
device are clean (Refer to
"Care and cleaning").
If the burner accidentally
goes out, the hob re-ignite
the burner 3 times. If the
flame still does not light,
appears.
If the warning
turn off and turn on again the
hob.
When the display function
reappears, after light
animation, touch
it and then touch
seconds. When you see
the warning is reset (Refer to
"Troubleshooting").
5.3 Turning the burner off
To put the flame out, touch the control
bar to the off position
WARNING!
Always turn the flame down
or switch it off before you
remove the pans from the
burner.
ENGLISH
15
appears,
, release
within 3
.
Advertisement
Table of Contents
