Panasonic VL-SWD501AZ Quick Start Manual

Key Features
• Wireless Handset:
Check visitors on Wireless Monitor, respond promptly and talk from living room, kitchen, everywhere home and while you are doing something
else. UP to 6 wireless monitor connectable. Max wireless range is 100m with no obstacles. You can add on repeaters expand the range. UP to 2 DECT repeater connectable.
• Large Touch Panel:
The main monitor has a large, 5 inch wide screen that clearly shows each visitor's face. You can simply touch the screen to activate an
approximate 2x zoom horizontally and vertically.
• Electric Lock Release Support for Gate:
• Wide-Angle Camera:
Wide-angle lens covers approximately 170 degrees horizontally and 115 degrees vertically.
• SD Card Recording:
Automatically record video images of visitors to SD card. It will record up to 3,000 visitors (30 seconds per visitor).
(The SD Memory Card is sold separately.)
• Wireless Sensor Cameras:
that you are concerned about. UP to 4 wireless sensor camera connectable.
• Night Vision:
Door Station is equipped with LED lights (illumination lamp). It enables the colour display of visitors at a distance of about 50 cm at night.
Wiring Schematic Diagram
220-240 V AC
POWER SUPPLY UNIT
Wire type and length
Wiring run
A
Main monitor – Doorphone
Main monitor – Power supply unit B
2
Doorphone – Electric lock* C
Main monitor – Connection device for
D
option output (A contact)* 2
Wireless sensor camera –
–
Power supply unit
Wireless sensor camera –
–
External sensor
Accessory Information
For the Sub Monitor:
AC adaptor × 1 (PNLV226AL), Rechargeable batteries × 2, Charger × 1
For the Door Station:
<VL-V554BX> Mounting base × 1 & screw (3.8 mm x 20 mm) × 2, Screw (4 mm x 12 mm) × 4, Name plate × 2, Hex wrench × 1
<VL-V554UBX> Flush mounting box × 1, Screw (4 mm x 25 mm) × 4, Name plate × 2, Hex wrench × 1
For the Main Monitor Station:
Optional Accessories
Door Station
(Doorphone)
VL-V554BX
VL-V554UBX
VL-SWD501AZ/UAZ
The gate or door lock can be easily and quickly released even from the second floor of the house.
By installing the optional DECT Wireless Sensor Camera, you can use human (heat) and motion sensors to monitor locations
MAIN MONITOR
A
NP
NP
NP
D
B
24 V DC
Connection device for option output (A contact)
NP: Non-polarised
Wire type*
Diameter
φ 0.65 mm 22 AWG
φ 1.0 mm
18 AWG
φ 0.5 mm CAT 5
φ 0.65 mm 22 AWG
φ 1.0 mm
18 AWG
φ 0.5 mm - φ 1.2 mm (24 AWG - 17 AWG)
φ 0.5 mm - φ 1.2 mm (24 AWG - 17 AWG)
φ 0.65 mm 22 AWG
φ 1.0 mm 18 AWG
φ 0.5 mm - φ 0.8mm (24 AWG - 20 AWG)
Power supply unit* (VL-PS241) × 1, Mounting bracket × 1, Cable binder × 1, Screw (4 mm x 16 mm) × 2
*Including AC cable × 1, Cable binder × 1, Screw (4 mm x 40 mm) × 2
Door Station
(Doorphone)
VL-V522LBX
Wireless Video Intercom System
DOORPHONE 1
C
NP
NP
Power
supply
DOORPHONE 2
C
NP
Power
supply
1
Length (Max.)
100 m
130 m
50 m
10 m
20 m
According to specification of connected device.
According to specification of connected device.
50 m
100 m
According to specification of connected device.
Must be no longer than 20 m.
Wireless Wireless Sensor Camera
Monitor Station
VL-WD812AZ
(Sub monitor)
VL-WD613AZ
Optional
Wireless Camera
Electric lock
12 V AC/DC
Electric lock
12 V AC/DC
*1 Type: Single-pair cable with outer sheath (jacket) Conductor: Copper
solid
• A certified power supply wiring has to be used with this equipment.
The relevant national installation and/or equipment regulations shall
be considered. A certified power supply wiring not lighter than ordinary
polyvinyl chloride flexible wiring according to IEC 60227 shall be used.
*2 When using an electric lock or a connection device for option output (A
contact), select a device that meets the following guidelines:
• Electric lock connection terminal (S1/S2):
- N/O dry closure contact
- 12 V AC/DC, less than 1 A
• Connection device for option output (A contact) terminal (OUT1/OUT2):
- 24 V AC/DC, less than 0.3 A (minimum contact: 5 V DC 1 mA)
DECT Repeater
VL-FKD2AZ