GE BiliSoft 2.0 Operation Manual page 52

Phototherapy system
Table of Contents

Advertisement

Manufacturer's Guidance and Declaration Regarding
Electromagnetic Emissions
The BiliSoft 2.0 is intended for use in the electromagnetic environment specified below. The customer
or the user of the BiliSoft 2.0 should assure that it is used in such an environment.
Emissions Test
RF emissions CISPR 11
Harmonic emissions IEC
61000-3-2
Voltage fluctuations/flicker
emissions IEC 61000-3-3
Manufacturer's Guidance and Declaration Regarding
Electromagnetic Immunity
The BiliSoft 2.0 is intended for use in the electromagnetic environment specified below. The customer
or the user of the BiliSoft 2.0 should assure that it is used in such an environment.
Immunity Test
Electrostatic discharge
(ESD) IEC 61000-4-2
Electrical fast
transient/burst IEC 61000-
4-4
Surge IEC 61000-4-5
Voltage dips, shorts
interruptions and voltage
variations on power supply
input lines IEC 61000-4-11
9-2
Compliance
Electromagnetic Environment Guidance
The BiliSoft 2.0 uses RF energy only for its internal function. Its
Class B
RF emissions are very low and are not likely to cause any
interference in nearby equipment.
Class A
The BiliSoft 2.0 is suitable for use in all hospitals and domestic
residences directly connected to a public low voltage power
utility.
Complies
IEC 60601 Test Level
+/- 8kV contact
+/- 15kV air
+/- 2kV for power supply
line.
100 kHz Repetition Rate
+/- 1kV line to line
<5 % Ut (>95 % dip in Ut)
for 0.5 cycle
At phase angles of :
Compliance Level
+/- 8kV contact
+/- 15kV air
+/- 2kV for power supply
line.
100 kHz Repetition Rate
+/- 1kV line to line
<5 % Ut (>95 % dip in Ut)
for 0.5 cycle
At phase angles of :
Electromagnetic
Environment
Guidance
Floors should be wood,
concrete or tile. If
floors are carpeted, the
relative humidity
should be at least 30%.
Electric power supplied
should be that of a
typical public low
voltage power utility.
Electric power supplied
should be that of a
typical public low
voltage power utility.
Electric power supplied
should be that of a
typical public low
voltage power utility
.
1

Advertisement

Table of Contents
loading

Table of Contents