Sealey MK50.V3 Instructions

thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instructions
1. safety
familiarise yourself with the application, limitations and hazards of the panel stand.
9
maintain the panel stand in good condition (use authorised replacement parts).
9
Keep the panel stand clean for best and safest performance.
9
locate the panel stand in a suitable work area.
9
WaRnInG! use the panel stand on level and solid ground, preferably concrete.
‰
dO nOt overload the panel stand.
8
dO nOt climb on the panel stand.
8
dO nOt use the panel stand for any purpose other than for which it is designed.
8
dO nOt use the panel stand if any parts are damaged or missing as this may cause failure and/or personal injury.
8
Keep the work area clean, uncluttered and ensure that there is adequate lighting.
9
Keep children and unauthorised persons away from the work area.
9
WaRnInG! the warnings, cautions and instructions discussed in this manual cannot cover all possible conditions and situations that
‰
may occur. it must be understood that common sense and caution are factors which cannot be built into this product, but must be
applied by the operator.
2. IntROductIOn
Versatile stand suitable for a wide variety of body shop applications. Work height is fully adjustable by lengthening chains. foam cushioned
supports help prevent marking panel. folds away when not in use.
3. specIfIcatIOn
model no ................................................................. mK50.V3
Width ........................................................................ 1000mm
folded Height ........................................................... 1100mm
4. asseMbly
4.1. Push rubber feet on to ends of legs as shown.
4.2. slide legs fig.1.1 into panel supports fig.1.2 and fix using hook
bolts fig.1.3 as shown.
4.3. Bolt the two halves of the stand together using the bolts / nuts /
washers supplied. ensure hooks face inwards.
4.4. suspend the chains between the hooks as shown to obtain
required height.
4.5. Panel stand can be folded up when not in use for ease of storage.
WArninG! take care not to trap fingers.
‰
© Jack sealey limited
instructions for
panel stand
MK50.V3
model no:
Original Language Version
fig.1
mK50.V3 | issue 1 23/08/16