Information/Warning/Error - FujiFilm Frontier-S DX100 Service Manual

3.3.2 Information/Warning/Error

Error
Name
ID
Trimmed Waste Paper Box full
I-1311
Ink Tube life near end (Notice)
I-2101
Decompression Pump Unit life near
end (Notice)
I-2102
Passage Pump maintenance near end
(caution)
I-2103
Suction Pump maintenance near end
(warning)
I-2104
Ink low
I-2201
AID out of guaranteed temperature error Cannot perform [Detect Clogging] correctly.
I-2307
Maintenance Cartridge near end
I-2401
Job size limit warning (SDK)
I-5201
DX100 Service Manual
Table 3-2. Information
Message
Check the Trimmed Waste Paper Box.
Empty the box if it is full.
It is nearly time to replace parts.
• Ink Supply Tube
Contact a technical representative.
You cannot print if parts have reached the end of their service life.
It is nearly time to replace parts.
• Ink Supply Decompression Pump
Contact a technical representative.
You cannot print if parts have reached the end of their service life.
It is nearly time to replace parts.
• Ink Supply Pump
Contact a technical representative.
You cannot print if parts have reached the end of their service life.
It is nearly time to replace parts.
• Ink Suction Pump
Contact a technical representative.
You cannot print if parts have reached the end of their service life.
Ink Low
(X*)
Prepare a new Ink Cartridge.
You may continue printing until replacement of the Ink Cartridge
is required.
Room temperature may not be within the guaranteed operating
range.
Check the room temperature.
Replace the Maintenance Cartridge soon
Prepare a new Maintenance Cartridge.
You may continue printing until replacement of the Maintenance
Cartridge is required.
Amount of data in print jobs sent to printer nearly at maximum
limit.
Stop sending the current print job and send the remaining pages as
another print job.
3.3Troubleshooting by Error Message
Cause (Status)
Trimmed Waste Paper Box Usage became full.
The replacement time of Ink Tube is near.
The replacement time of Decompression Pump
Unit.
The replacement time of Ink Passage Pump Unit.
The replacement time of Ink Suction Pump Unit.
The replacement time of the corresponding color' s
Ink Cartridge is approaching.
The temperature of the room where the printer is
installed is out of the guaranteed range. (P. 17)
The replacement time of Maintenance Cartridge is
approaching.
The amount of data of the print jobs being sent to
the printer has nearly reached the maximum limit.
Remedy
Remove the scraps from the Trimmed Waste Paper
Box.
1. Replace the Ink Tube with a new one. (P. 116,
P. 186, P. 179)
2. Reset the counter of the Ink Tube. (P. 219)
1. Replace the Decompression Pump Unit.
(P. 181)
2. Reset the counter of the I Decompression Pump
Unit. (P. 219)
1. Replace the Ink Cartridge Holder. (P. 175,
P. 179)
2. Reset the counter of the Ink Cartridge Holder.
(P. 219)
1. Replace the Capping Unit. (P. 182)
2. Reset the counter of the Capping Unit. (P. 219)
Check the remaining ink level on the "Printer
Status" screen of the Service Program. (P. 217)
If the room temperature is within the guaranteed
range, delete all the print jobs and perform
Diagnostic Cleaning with the maintenance tool.
Check the remaining maintenance Cartridge level
on the "Printer Status" screen of the Service
Program. (P. 217)
Delete all the print jobs once and send them in parts.
51