Sealey AP0618.V3 Instructions

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear protective
instruction gloves
manual
1. sAFetY
wArninG! ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this
‰
workbench.
Wear protective gloves and goggles during assembly.
9
locate workbench in a suitable work area.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
wArninG! Use workbench on level and solid ground, preferably concrete.
‰
Keep the workbench clean and tidy in accordance with good workshop practice.
9
Keep children and unauthorised persons away from the work area.
9
do not use the workbench for any purpose other than that for which it is designed.
8
do not use the workbench outdoors.
8
do not place the workbench in a damp or wet location or an area where there is condensation.
8
do not clean the workbench with any solvents which may damage the surfaces or the protective coating.
8
do not move the workbench when there are items placed on it.
8
do not overload the workbench.
8
do not undertake work on the workbench without the workpiece being adequately secured. Use clamps or a vice (not included but available
8
from your Sealey stockist), to secure the workpiece.
wArninG! The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions and situations that
‰
may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be applied by the
operator.
2.
introdUction
Thick 25mm mdF worktop, used for adding extra rigidity and durability. powder coated steel frame, for added corrosion resistance. Four
adjustable feet for levelling on uneven ground.
3. speciFicAtion
model no: ............................................................. AP0618.V3
Weight: ...................................................................... 48.08kg
Size (W x d x H):...................................1800 x 600 x 925mm
maximum capacity (evenly distributed): ....................... 500kg
4. contents
4.1. Unpack the unit and confirm that you have all the parts listed.
no. description
1 mdF table top
2 H leg frame
3 Horizontal back brace
4 m8 x 70mm pan head bolt
5 m8 x hex nut
5. AssemblY
5.1. Assemble on a soild, level surface - avoid carpet.
5.2. The assistance of a second person will be required during
assembly.
5.3. Tools required: rubber mallet, crosshead screwdriver,
adjustable spanner.
© Jack Sealey limited
workbench 1.8mtr steel with 25mm
wooden top
model no:
Wear goggles
Qty.
1
2
1
12
12
Original Language Version
Ap0618.V3
AP0618.V3| Issue:1 27/04/18