Table of Contents
Advertisement
13. Tip: Avoid pinching the wires. If necessary,
tilt the Console Bracket (26) upward to make
this step easier. Attach the Console Deck (89)
to the Console Bracket with four M4 x 12mm
Screws (81); start all the Screws, and then
tighten them.
14. The Console (6) requires three AA batteries (not
included); alkaline batteries are recommended.
Do not use old and new batteries together or
alkaline, standard, and rechargeable batter-
ies together. IMPORTANT: If the Console has
been exposed to cold temperatures, allow
it to warm to room temperature before you
insert batteries. Otherwise, you may dam-
age the console displays or other electronic
components.
See the inset drawing. Press the tab on the
battery cover (K), and remove the battery cover.
Next, insert three batteries into the battery com-
partment; make sure to orient the batteries
as shown by the diagram inside the battery
compartment. Then, reattach the battery cover.
15. After the exercise bike is assembled, inspect it to make sure that it is assembled correctly, that it
functions properly, and that all parts are properly tightened. Extra parts may be included. Place a mat
under the exercise bike to protect the floor or carpet.
13
89
14
6
13
Avoid pinching
26
the wires
81
81
K
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the TOUR DE FRANCE CBC and is the answer not in the manual?
Questions and answers
How can I replace the drive belt
The provided context does not contain specific instructions for replacing the drive belt on the Pro-Form TOUR DE FRANCE CBC. However, based on common practices, replacing the drive belt generally involves these steps:
1. Unplug the Bike – Ensure the bike is powered off and unplugged for safety.
2. Remove the Outer and Inner Belt Covers – Unscrew and detach the belt covers (parts 34 and 35) to access the belt.
3. Loosen the Tension – Locate the idler pulley or tension adjustment mechanism and loosen it to release the drive belt tension.
4. Remove the Old Belt – Slide the old drive belt (part 46) off the pulley and flywheel.
5. Install the New Belt – Position the new drive belt onto the pulley and flywheel.
6. Adjust the Tension – Re-tighten the tensioning mechanism to ensure proper belt tension.
7. Reattach the Covers – Secure the belt covers back in place.
8. Test the Bike – Power on the bike and test for smooth operation.
If further details are needed, refer to the user manual or seek professional assistance.
This answer is automatically generated