To replace the on-board backup battery, follow the steps below.
Danger of explosion if battery is replaced incorrectly.
!
Replace only with the same or equivalent type recommended by the
Caution
equipment manufacturer. Dispose of used batteries according to the
manufacturer's instructions.
Avoid touching areas of integrated circuitry; static discharge can damage
circuits.
Caution
Attach an ESD strap to your wrist. Attach the other end of the ESD strap
Use ESD
to an electrical ground. (Note that the system chassis may not be grounded
if it is unplugged.) Secure the ESD strap to your wrist and to ground
throughout the procedure.
Wrist Strap
1. To remove the battery from the module, carefully pull the battery
2. Before installing a new battery, make sure that the battery pins are
3. Not the battery polarity and press the new battery into the socket.
Note
4. Recycle or dispose of the old battery according to local regulations
http://www.motorola.com/computer/literature
from the socket.
clean.
No soldering is required when the battery is in the socket.
and manufacturer's instructions.
Replacing Lithium Batteries
1-23
1