Procedure - Nokia Beacon 6 Product Manual

Nokia WiFi Beacon 6 Product Guide

7.6 Procedure

Issue: 01
Prolonged exposure to direct sunlight can damage the unit.
Use this procedure to replace a Beacon 6 (HA-0336G-A).
3FE-47429-AAAA-TCZZA
Make sure all sources of power are turned
Danger 2 —
off and have no live voltages present on feed lines or
terminals. Use a voltmeter to measure for voltage before
proceeding.
Always contact the local utility company
Danger 3 —
before connecting the enclosure to the utilities.
direct sunlight.
national laws and regulations that may be applicable to this
installation.
Observe the following:
Note 2 —
•
The device should be installed in accordance with the
applicable requirements of the NEC or CEC. Local
authorities and practices take precedent when there is
conflict between the local standard and the NEC or
CEC.
•
The device must be installed by qualified service
personnel.
•
Indoor units must be installed with cables that are
suitably rated and listed for indoor use.
•
See the detailed specifications in the
(HA-0336G-A) unit data sheet
ranges for these devices.
Keep indoor devices out of
Caution —
Observe the local and
Note 1 —
for the temperature
Replace a Beacon 6 (HA-0336G-A)
Beacon 6
49