Procedure - Nokia Beacon 6 Product Manual

Nokia WiFi Beacon 6 Product Guide

6.6 Procedure

Use this procedure to install a Beacon 6 (HA-0336G-A).
1
2
Issue: 01
Observe the local and national laws and regulations that
Note 1 —
may be applicable to this installation.
•
•
•
•
Place the unit on a flat surface, such as a desk or shelf.
Note — The Beacon 6 (HA-0336G-A) cannot be stacked with another or
with other equipment. The installation requirements are:
•
•
allow a minimum 50 mm clearance from the side vents
•
do not place any heat source directly above the top cover or below the bottom
cover
Review the connection locations, as shown in Figure 9.
3FE-47429-AAAA-TCZZA
Observe the following:
Note 2 —
The device should be installed in accordance with the
applicable requirements of the NEC or CEC. Local
authorities and practices take precedent when there is
conflict between the local standard and the NEC or
CEC.
The device must be installed by qualified service
personnel.
Indoor units must be installed with cables that are
suitably rated and listed for indoor use.
See the detailed specifications in the
(HA-0336G-A) unit data sheet
ranges for these devices.
allow a minimum 100 mm clearance above the top cover
Beacon 6
for the temperature
Install a Beacon 6 (HA-0336G-A)
45