Riser Card - Fujitsu TeamPoS 2000 Installation And Maintenance Manual

TeamPoS 2000
7.14

Riser Card

Note: Riser cards should be replaced only by the new riser card.
Installation process should be the same for both the M and A motherboard.
Caution: To prevent electric shock, confirm that the AC cable is removed from
the AC outlet anytime the covers are removed. Be sure to observe all
ESD precautions and power off procedures.
1. Remove the AC power cable.
2. Remove the front cover (see section 5.1.1).
3. Remove the side cover (left) (see section 5.1.2).
4. Remove the top cover (see section 5.1.4).
5. Disconnect the power cable from the hard disks, floppy, and media player.
6. Remove the PC board (see section 7.2).
7. Remove the retail I/O board or TeamCOMBO board (see section 7.13).
8. Remove PCI cards (see section 5.1.5).
9. Disconnect the signal cables from hard disk drive(s).
10. Disconnect the cables (four in total) between the riser card, the operation panel, and
the power supply unit.
90000291 Rev 3.0
MAINTENANCE MANUAL
7-25