Switching The Master Heater And Pump Controls On/Off - Nordson ProBlue Flex User Manual

Switching the Master Heater and Pump Controls On/Off

E 2020 Nordson Corporation
When you power-up the melter, by default, the Master Heaters and Pump
controls are switched Off. You must manually switch them On.
1
2
1. Master Pump control
S
To toggle the Master Heater control On, Press the
button. The LED illuminates. Press the master control button again to
switch it Off.
However, you can make use of the Heaters on Upon Startup (System
Settings | Global Settings) to change this behavior.
S
To toggle the Master Pump control On, press
flashes.
S
If AutoPump is enabled, the pump button will flash, indicating that the
Master Pump control will be toggled On as soon as system temperature
ready is achieved. If you press the Master Pump Control button again,
AutoPump becomes disabled, although only for this one time. When
Temperature Ready is achieved, the Master Pump control remains Off. In
this case, pushing the Master Pump Control button again will switch the
Master Pump Control On, since system temperature ready has already
been achieved.
S
If you press the Master Pump control button with AutoPump disabled and
before the system is not at Temperature Ready, AutoPump is
momentarily Enabled and the Pump button flashes.
ProBlue Flex OEM User's Guide
2. Master Heat control
master control
The Pump LED
23
Part 1129255_01