Table of Contents
Advertisement
Available languages
Available languages
Installation
Flat cooker hoods
DA 3160, DA 3190
^ Disconnect the cooker hood from the
mains electricity supply.
^ Then connect all components on the
control module as described in
"Electrical connection" and "Wiring
diagram".
The control module connects to the top
of the cooker hood.
^ Screw the control module onto the
two pillars as shown.
^ If a light switch is connected or the
potential free contact used then the
earth lead must be connected in
between the control module and
appliance housing.
22
^ Open the lid to the connection box
using a screwdriver.
If necessary a knife can be used to
cut into the side of the lid.
^ Connect the control module cable to
the circuit board in the cooker hood.
^ Feed the cable through the opening
in the lid and then close the lid.
^ Then reconnect the cooker hood to
the mains electricity supply.
Advertisement
Table of Contents
