7 Assembling and Disassembling Procedure.
7.1.
Disassembling Procedures
Caution:
Do ensure that the main unit is set to service mode before repair.
For information on setting to service mode for changer unit, pls refer to section 5.3.
Note:
Change unit (CRS1) reliability test must be carry out in complete unit or using the Service P.C.B (Refer section 8).
7.1.1.
Disassembly of UD Base Assembly
Step 1: Press the 2 claws downwards and push the top
cover backwards and lift up the top cover to remove it.
Caution: Do not exert strong force on the claws when
pressing the claws.
Step 2: Release the top cover from the tray rear stopper
as arrow shown and remove the top cover.
Step 3: Remove the open lever spring from the gear cover.
Caution: Ensure the open lever spring is handle
properly and keep it in a safe place.
Step 4: Push forwards and remove the gear cover as
arrow shown.
53
CRS1