Removing The Chassis Cover - Huawei IVS1800 User Manual

IVS1800 Video Management System
User Manual
1.
2.
Step 3 Install a new hard disk.
1.
2.
Issue 02 (2021-01-27)
Use a PH2 screwdriver to remove the two black screws on the rear of the
chassis cover, and take off the chassis cover.
Figure 5-2 Removing the chassis cover
Remove two black screws on each side of the chassis and the silvery white
one on top of the hard disk tray, raise the hard disk tray by 45 degrees, and
take out the upper and then lower layers of hard disk tray.
Figure 5-3 Removing the hard disk tray
Place the hard disk with ports facing upwards and align the screw holes on
the hard disk tray with the hard disk and fasten the screws. Before the
installation, ensure that the fastener of the hard disk tray is on a different
side from the hard disk port, as shown in the lower left figure.
Figure 5-4 Installing hard disks
Insert the hard disk tray back at 45 degrees with the opening of its locking
buckle facing downwards, hold the screw in the red-framed part to lower the
hard disk tray until it is level, and fasten the black screws on the left and right
sides and the white screw on the top.
Copyright © Huawei Technologies Co., Ltd.
5 O&M
55