Commissioning Cameras (Smart Eth Gateway Networking Scenario); Commissioning Ipc6325 Cameras - Huawei IVS1800 User Manual

IVS1800 Video Management System
User Manual
----End
Follow-up Procedure
Commission other cameras by referring to this section.
4.4 Commissioning Cameras (Smart ETH Gateway
Networking Scenario)

4.4.1 Commissioning IPC6325 Cameras

Prerequisites
●
●
●
Context
●
●
●
Issue 02 (2021-01-27)
Parameter
I-frame interval
Layered
encoding
JPEG quality
If multiple cameras are accessed, retain the connection of one camera and
disconnect connections from other cameras. After commissioning the
connected camera, commission other cameras in the same way.
The camera has connected to the smart ETH gateway and the smart ETH
gateway communicates properly with the ECC800-Pro.
The camera software version is later than V500R019C30.
Before commissioning the IPC6325 camera, set the IP address for the IPC6325
camera based on customer requirements.
Configure the internal IP addresses of the camera and VCN or IVS1800 and
the IP address of the LAN port on the ECC800-Pro in the same network
segment.
Configure the external IP addresses of the camera and VCN or IVS1800 and
the IP address of the WAN_1 port on the ECC800-Pro in the same network.
Copyright © Huawei Technologies Co., Ltd.
Description
This parameter is available only when you set Encoding
protocol to H.264 or H.265.
An I frame is an intra-coded frame that represents a
fixed image independent of other picture types. Each
group of pictures (GOP) begins with this type of frame.
A smaller I-frame interval indicates better video quality
and higher bandwidth consumption.
This parameter is available only when you set Encoding
protocol to H.264 or H.265.
To enable layered encoding, select Layered encoding.
This parameter is available only when you set Encoding
protocol to MJPEG.
A larger value indicates higher image quality.
4 Commissioning the IVS1800
28