Getting Started; Canceling The Display Demonstration; Setting The Demonstration Mode; Adjusting The Clock - Kenwood KDC-BT41U Instruction Manual

Getting Started

Canceling the display
demonstration
The display demonstration is always turned
on unless you cancel it.
When you turn on the power (or after you
reset the unit), the display shows:
[CANCEL DEMO] \ [PRESS] \ [VOLUME
KNOB]
Press the volume knob.
1
[YES] is selected as the initial setup.
Press the volume knob again to confirm.
2
[DEMO OFF] appears.
■
If no operation is done for about 15 seconds
or if you turn the volume knob to select
[NO] in step 2, [DEMO MODE] appears and
the display demonstration starts.

Setting the demonstration mode

Press the volume knob to enter
1
[FUNCTION].
Turn the volume knob to select [DEMO
2
MODE], then press to enter.
Turn the volume knob to select [ON] or
3
[OFF].
If [ON] is selected, display demonstration
starts if no operation is done for about 20
seconds.
Hold to finish the procedure.
4
6
English

Adjusting the clock

Press the volume knob to enter
1
[FUNCTION] mode.
2 Turn the volume knob to select
[SETTINGS], then press to enter.
Turn the volume knob to select [CLOCK],
3
then press to enter.
Turn the volume knob to select [CLOCK
4
ADJUST/ CLOCK ADJ], then press to
enter.
Clock hour flashes on the display.
Turn the volume knob to adjust the hour,
5
then press to enter minute adjustment.
Clock minutes flashes on the display.
Turn the volume knob to adjust the
6
minute, then press to confirm.
Press 4 / ¢ to move between the
hour and minute adjustment.
Hold to finish the procedure.
7