SunSetter EasyShade Replacement Instructions

Tools Needed: Phillips Screwdriver, 3mm Allen Wrench, 5/64" Allen Wrench
Parts Supplied: Replacement motor
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT IN PERSONAL INJURY!
PLEASE READ THESE INSTRUCTIONS COMPLETELY BEFORE PERFORMING THIS PROCEDURE.
1. Close your EasyShade completely, if possible.
2. Disconnect the Power Cord from the Solar Panel.
3. Remove the Cable Guide Stops from the bottom of
the Vinyl Coated cable on each side of the EasyShade
using a 5/64" Allen Wrench.
See Figure 1.
Cable Guide
Bracket
Figure 1
4. Pull the Vinyl Coated Cable out of the guide holes
in each end of the EasyShade drop down panel.
See Figure 2.
Guide Hole
Figure 2
©SunSetter Products, a Massachusetts Limited Partnership, 184 Charles Street, Malden, MA 02148
For Technical Support visit us at www.sunsetter.com/ownerscorner
or Call Toll Free 800-670-7071 • Fax 877-224-4944
Solar Powered Motorized EasyShade®
Motor Replacement Instructions
* Helper Needed *
Cable Guide Stop
Fabric Panel
Vinyl Coated
Cable
EASYSHADE
®
5. Coil the Vinyl Coated cable and secure with a piece
of masking tape.
See Figure 3.
Masking
Tape
Vinyl Coated
Cable
Figure 3
Note: Step 6 requires access to the Mounting
Brackets for removal of the Housing. If the Fabric
Panel can not be retracted, have a helper assist
you in rolling the Fabric Panel around the bottom
Leading Bar until the rolled up Fabric and Leading
Bar meet the Housing, then secure safely in place.
6. While your helper supports the EasyShade, loosen
the set screws on the Mounting Brackets. With the
aid of your helper remove the EasyShade from the
brackets and place it carefully in your work area.
7. On the end of the Housing opposite the motor,
remove the two Phillips head screws that secure the
end plate to the housing. Remove the end plate and
the white nylon insert from the roller bar and place
aside for use in reassembly.