Inhibit Mode; Inhibit 1 Speed; Inhibit 1 Operation - PG Drives Technology S45A Technical Manual

S- - I
DRIVE NSTALLATION

6.1.1 Inhibit Mode

The Mode parameter refers to the state in which the inhibit is active.
6.1.2

Inhibit 1 Speed

This parameter sets the maximum speed of the scooter when the Inhibit 1 input is active. The parameter is adjustable between 0
and 100% in steps of 1%.
When Inhibit Speed = 0 this acts as an inhibit. At this time the controller will refer to the Inhibit
Operation parameter to establish what type of inhibit will be created.
If the Inhibit Speed is greater than 0 then the controller will not enter an inhibit state.
6.1.3

Inhibit 1 Operation

This parameter is only effective if the Inhibit 1 Speed parameter has been set to 0.
The parameter can be set to one of two states:
Latched -
Non-Latched -
If set to Latched, then when Inhibit 1 is active the TruCharge display will step-up to indicate the scooter is charging.
Example - To provide a charge inhibit function that is active when Inhibit 1 is connected to 0V and is latching, program as below.
Mode = 1
Speed Limit Value = 0
Operation = Latched
If this inhibit is activated then the controller will cause the scooter to decelerate to a complete stop (as if the throttle has been
released).
44
Means the inhibitor, such as the charger plug, must be removed and the controller turned off and
on before the scooter can be operated again.
Means the controller can be reset to an operational state by removing the inhibitor.
PG D T
RIVES ECHNOLOGY
SK76745/10