Re-Addressing - ABB Smile 41 AS-i Series Original Instructions Manual

AS-i LED and Fault LED in combination / LED pairs:
AS-i (Green) Fault (Red)
OFF OFF
ON OFF
OFF ON
FLASH ON

Re-addressing

If two nodes in the same Smile 41 have been given the same address they can be re-addressed.
The push-button box is opened as shown below. A node is shut off when the jumper is removed. The arrow shows
the jumpers. Only one node may be active during re-addressing (only one jumper connected). When done, put
back all jumpers and assemble the box again. Test and verify the functions.
2TLC172255M0201, rev. D
AS-i power missing
Normal operation
No data exchange with master
No data exchange because address = 0
Position of AS-i LEDs:
1. Safe node 1
2. Safe node 2
3. Non-safe node
10 www.abb.com/jokabsafety