HP 98568A Installation Instruction page 189

HP 98562-66530 Human (System) Interface Board
a. Make a note that the following select codes have been used and are no
longer available:
• 7 - the built-in, standard-speed HP-IB interface.
• 9 - the built-in RS-232C Serial interface (unless you disabled the
interface in step 3).
• 14 - the Optional interface (unless you changed the select code in step
9 or did not purchase this option).
• 21 - the built-in LAN interface (unless you changed the select code in
step 6).
Use the "Select Code Record" form on the Chapter 5, "Interface Cards"
tab for this purpose.
Verification Test
1. Plug in the power cord. Turn your computer on and hold down the space
bar a few seconds.
2. Check the list of components displayed on the left-hand side of the screen:
• If the message,
HPIB, appears in the list, you have correctly installed the
built-in, standard-speed HP-IB interface.
• If the message,
HP98644 at 9, appears in the list, you have correctly
installed the built-in RS-232C Serial interface, and the interface is
enabled.
• If the message,
HP98643 at 21, appears in the list, you have correctly
installed the built-in LAN interface. (Note:
21
will be replaced by another
number if you changed the select code.)
• If the message,
HP98625 at 14, appears in the list, you have correctly
installed the Optional interface. (Note: 14 will be replaced by another
number if you changed the select code.)
If any of these messages does not appear, make sure there are no select code
conflicts and that the board is firmly seated in the slot. If you still have
problems, call your HP Service Representative for assistance.
Adding Interface Cards 5-93