Setting DRC
You can use this function to enjoy Dolby Digital sound when watching movies at low volume at night.
MAIN UNIT
1
2
3
To Exit Setup Mode
•
Wait for about 5 seconds or turn the VOLUME CONTROL of the main unit.
"SETUP MODE OFF" appears on the display and exits Setup Mode.
Setting DRC
STD : Sets DRC effect to standard.
•
•
MAX : Sets DRC effect to maximum.
MIN : Sets DRC effect to minimum.
•
21
(Dynamic Range Compression)
√
Press SETUP button.
•
"SETUP MODE" appears on the display and enters into Setup Mode.
Press INPUT button 3 times.
"DRC SETUP" appears on the display.
•
Press SURROUND button to set DRC.
•
Each time you press this button, DRC : STD
DRC : MAX
selected in turn.
You can only set this function via the main unit.
•
Test Tone
Use test tone to check the speaker connection status or level.
DRC : MIN will be
To Automatically Output Test Tone
√
REMOTE CONTROL
1
Press TEST TONE button.
•
Test signal will be automatically output as follows; F.L
S.B
S.L
S.W.
During test tone output, press ...† button to adjust the speaker output level
•
from -10 to +10 dB by 1 step.
To Stop Test Tone
•
Press TEST TONE button again.
GB
CEN
F.R
S.R
22