Fault And Error Codes; Identifying The Charger Serial Number - Delta-q IC Series User Manual

IC Series Battery Chargers User Manual
4. Press and release the Charger button to advance through the charge algorithms. The selected
charging algorithm will be displayed up to three times (e.g., P-0-1-1 for Algorithm 11).
5. Once the desired charging algorithm is displayed, press and hold the Charger button for 10 seconds to
confirm selection and exit Selection Mode. When the charge algorithm is confirmed, the Error Display
and Battery Charging Indicator lights turn off, while the blue AC Power Indicator remains lit. At this time,
the button can be released.
6. Press the Charger button to check the desired algorithm has been selected.
In some circumstances, the charging algorithm output will be altered to maintain safe operations. The unit
automatically reduces its output power if the temperature rises above set thresholds, or if the AC input voltage
is too low. If power is interrupted, and then returns, the charger will start and continue to operate without
hazard to the user or damage to the batteries.

FAULT AND ERROR CODES

Visit the Delta-Q Technologies support website at
codes
to review recommended actions.

IDENTIFYING THE CHARGER SERIAL NUMBER

The serial number is printed on the front of the charger. Use this number when requesting technical support.
Page 10 of 12
Copyright © 2020 Delta-Q Technologies Corp
https://support.delta-q.com
https://delta-q.com
fault and error
and search for