Delta-q QuiQ 912-24xx User Manual

SAVE THESE IMPORTANT

SAFETY INSTRUCTIONS

This manual contains important safety, operating, and
installation instructions – read before using charger.
Battery Safety Information
Warning:
Use charger only on battery systems with an
algorithm selected that is appropriate to the specific battery type.
Other usage may cause personal injury and damage. Lead acid
batteries may generate explosive hydrogen gas during normal
operation. Keep sparks, flames, and smoking materials away from
batteries. Provide adequate ventilation during charging. Never
charge a frozen battery. Study all battery manufacturers' specific
precautions such as recommended rates of charge and removing
or not removing cell caps while charging.
Electrical Safety Information
Danger:
Risk of electric shock. Connect charger power cord to
an outlet that has been properly installed and grounded in
accordance with all local codes and ordinances. A grounded outlet
is required to reduce risk of electric shock – do not use ground
adapters or modify plug. Do not touch uninsulated portion of
output connector or uninsulated battery terminal. Disconnect the
AC supply before making or breaking the connections to the
battery while charging. Do not open or disassemble charger. Do not
operate charger if the AC supply cord is damaged or if the charger
has received a sharp blow, been dropped, or otherwise damaged in
any way – refer all repair work to qualified personnel. Not for use by
children.
Operating Instructions
1. Always connect the charger to a GROUNDED outlet. When using an extension cord, avoid
excessive voltage drops by using a grounded, 3-wire, 12-AWG cord no longer than 30m (100').
2. AVOID connecting a QuiQ charger and another device to a single 15A/20A circuit or the circuit
may become overloaded.
3. Charger 10-LED Display
User's Guide for:
QuiQ 912-24xx / 36xx / 48xx / 72xx
LED indications following "Power-On Self Test":
Ammeter Solid:
(Amber)
Flashing:
80% Charge Solid:
(Amber)
Flashing:
100% Charge Solid:
(Green)
Flashing:
AC On Solid:
Flashing:
(Amber)
Fault Flashing:
(Red)
INFORMATIONS IMPORTANTES
DE SÉCURITÉ
Conserver ces instructions. Ce manuel contient des instructions
importantes concernant la sécurité et le fonctionnement.
Information de Sécurité de la Batterie
Attention:
Utiliser le chargeur seulement sur les batteries
avec un algorithme approprié au type spécifique de batterie.
D´autres types de batteries pourraient éclater et causer des
blessures ou dommages. Les batteries peuvent produire des gaz
explosives en service normal. Ne jamais fumer près de la batterie
et éviter toute étincelle ou flame nue à proximité de ces derniers.
Fournisser la bonne ventilation lors du chargement. Ne jamais
charger une batterie gelée. Prendre connaissance des mesures de
précaution spécifiées par le fabricant de la batterie, p. ex., vérifier
s´il faut enlever les bouchons des cellules lors du chargement de la
batterie, et les taux de chargement recommandés.
Information de Sécurité Électrique
Danger:
Risque de chocs électriques. Ne pas toucher les
parties non isolées du connecteur de sortie ou les bornes non
isolées de la batterie. Toujours connecter le chargeur à une prise
de courant mise à la terre. Ne pas ouvrir ni desassembler le
chargeur – referer toute reparations aux personnes qualifiés. Pas à
l´usage des enfants.
Displays approximate scale of current output
during bulk phase.
High internal charger temperature. Current
output reduced.
Also displays algorithm #1-6 for 11 seconds
if no battery is connected.
Bulk charge phase complete, 80% charged.
In Absorption phase.
With no battery connected, indicates
algorithm # selected by number of flashes.
Charging complete. Charger in
Maintenance Mode.
Absorption phase complete. In Finish phase
AC Power good
Low AC Voltage, check voltage and
extension cord length (max 100', 12-AWG).
Charger error. Reset charger power and
refer to Troubleshooting below.