Download
Share
Print this page
Power-Pole Blade Installation Manual
  1. Manuals
  2. Brands
  3. Power-Pole Manuals
  4. Boating Equipment
  5. Blade
  6. Installation manual

Power-Pole Blade Installation Manual

Shallow water anchor
Hide thumbs Also See for Blade:
1
2
3
4
5
6
7
8

Advertisement

Quick Links

Download this manual
INSTALLATION MANUAL
®
Power-Pole
Blade Edition
Shallow Water Anchor
Installation Instructions
CAUTION: Read this instruction manual carefully. Become
familiar with the controls and know how to operate the Power-
Pole shallow water anchor system safely.
US Pat No. 6,041,730

Advertisement

loading
Need help?

Need help?

Do you have a question about the Blade and is the answer not in the manual?

Questions and answers

Related Manuals for Power-Pole Blade

Summary of Contents for Power-Pole Blade

  • Page 1 INSTALLATION MANUAL ® Power-Pole Blade Edition Shallow Water Anchor Installation Instructions CAUTION: Read this instruction manual carefully. Become familiar with the controls and know how to operate the Power- Pole shallow water anchor system safely. US Pat No. 6,041,730...
  • Page 2 The information contained here describes the proper procedures for safely installing your Power-Pole shallow water anchor. CAUTION: Do not use the Power-Pole shallow water anchor as your primary anchorage. Never leave your boat unattended while anchored solely with the Power-Pole shallow water anchor.

  • Page 3: Vertical Positioning

    • Heat gun must be at least 4” above this straight edge. • 4’ foot straight edge NOTE: If the Power-Pole anchor is mounted lower than • Marine grade sealant the 4” minimum, the vessel may experience adverse • Fine point marker handling effects.

  • Page 4: Choose A Mounting Location

    Step 3: Hydraulic Pump Unit (HPU) ® Step 2: Mounting the Power-Pole Choose a mounting location 1. Transom mounting: The hydraulic tubing can be 1. Locate a dry compartment in the vessel with ample routed through either side of the stern bracket.
  • Page 5 Step 4: Continued Step 5: Continued 5. Once the bracket is securely fastened, use a 9/16” 2. The hydraulic tubing may be routed in one of two wrench to attach the HPU to its bracket using the (2) ways. It may be routed either over the transom or 3/8”...
  • Page 6 HPU should flash indicating that the unit has power. 2. Use the “down” button on the HPU to deploy the Power-Pole anchor to the point where it makes contact with a solid surface. Keep the “down” button Figure 5...
  • Page 7 Step 7: Programming Dual Units Single Wireless Controller NOTE: Anchors are preprogrammed as a single unit. NOTE: The Power-Pole comes paired to the included When using only one anchor, do not program as Dash Switch and Key Fob remotes. When installing a port or starboard.
  • Page 8 Or you may choose to use adhesive strip also supplied. Need help? Contact our Technical Support Team at 813.689.9932 option 2 9010 Palm River Road, Tampa, Florida 33619 Phone 813-689-9932 Fax 813-689-8883 www.power-pole.com man-install-rev062014 ©2014 all rights reserved. Power-Pole Shallow Water Anchor U.S. Patent No. 6,041,730...