Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Power-Pole Micro Anchor
Summary of Contents for Power-Pole Micro Anchor
- Page 1 Original Instructions INSTALLATION & OWNER’S GUIDE Powered by...
- Page 2 Welcome to the world of Power-Pole ® the original shallow water anchor. 2 | MICRO Installation & Owner’s Guide 2018 | www.power-pole.com...
- Page 3 Inside you’ll find information on safe use and proper maintenance of your shallow water anchor. It also contains your warranty information. If you have questions about your new MICRO anchor we’re always here to help − call our Technical Support Team at 1+ (813) 689-9932 option 2 or visit our website at www.power-pole.com for FAQs, videos and technical support.
-
Page 4: Included Hardware
It’s the first of its kind – a super-compact powerhouse that was built to give you the ultimate shallow water fishing experience. Please read all installation instructions carefully. The information contained here describes the proper procedures for safely installing your Power-Pole shallow water anchor. Included Hardware: Installation Tools: Qty. -
Page 5: Deck Mount
To determine correct adapter plate go to To order go to www.power-pole.com or an authorized dealer. www.power-pole.com. Additional hardware Micro may be required. Transom Clamp Bracket Adapter Plate Micro Bracket MICRO Installation & Owner’s Guide 2018 | www.power-pole.com | 5... - Page 6 MICRO ANCHOR BOW MOUNT BRACKET To order go to www.power-pole.com. or an authorized dealer. NOTE: For mounting Micro anchor in combination with a bow mounted trolling motor. Mounts between the trolling motor base and boat deck. Trolling Motor Bow Mount Bracket...
- Page 7 Fasten the end of quick release pull cord to quick release clamp handle by tying them together using a knot. MICRO Installation & Owner’s Guide 2018 | www.power-pole.com | 7...
-
Page 8: Attaching Power
MICRO Driver Unit will begin flashing green. NOTE: If 12 volt battery is not available, the Micro Driver Unit can also be powered by the Micro Battery Pak, sold seperately. 8 | MICRO Installation & Owner’s Guide 2018 | www.power-pole.com... - Page 9 Mark and drill a hole with 7/64” drill bit to fasten switch using the (2) screws supplied (do not over tighten). Or you may choose to use adhesive strip also supplied. MICRO Installation & Owner’s Guide 2018 | www.power-pole.com | 9...
-
Page 10: Operation
Here you will find information on all of the functions, safe use, and proper maintenance of your MICRO shallow water anchor. If you have questions, contact our Technical Team @ ® 1+(813) 689-9932 option 2 or visit our website at www.power-pole.com. 10 | MICRO Installation & Owner’s Guide 2018 | www.power-pole.com... -
Page 11: Calibration Instructions
4. Once the calibration is complete the programming LED will return to flashing green. Your MICRO Driver Unit is now ready for use. 21” of clearance is required to calibrate Figure 2 MICRO Installation & Owner’s Guide 2018 | www.power-pole.com | 11... -
Page 12: Standard Mode
Standard Key Fob Remote Control (FIG. 4) STANDARD MODE To raise or lower the Power-Pole MICRO anchor, press and hold either the UP or DOWN button on the key fob. The anchor will only continue to move so long as you press the button. - Page 13 Auto Up/Auto Down and bottom sensing. • Troubleshoot with AMP streaming instant diagnosis. The information is sent directly to the Power-Pole Technical Support Team so we can instantly see what’s happening and you can count on little or no down time.
-
Page 14: Maintenance
With the spike removed, double tap the Key Fob or Dash Switch DOWN button to run the unit a full 30 seconds while simultaneously flushing with low flow water. Repeat as needed to clean all debris from spike pocket mechanical parts. 14 | MICRO Installation & Owner’s Guide 2018 | www.power-pole.com... -
Page 15: Frequently Asked Questions
A: The MICRO works best on boats 1,500 pounds or less this includes people and gear. Q: Why is the Power-Pole spike the best? A: Power-Pole 3/4” spikes feature a comfort grip handle and have a 1/4-20 threaded insert on the top for adding flags, lights or cameras. Power-Pole spikes are available in two strengths: 1) Our Ultra-lite Spike is strong, yet lightweight. -
Page 16: Shooting Guide
6. Place the board and rubber switch membrane back into the Dash Switch base and ensure that the rubber switch membrane is seated properly prior to installing the cover plate (FIG. 7) Figure 6 Figure 7 16 | MICRO Installation & Owner’s Guide | www.power-pole.com... -
Page 17: Optional Accessories
• Use only genuine Power-Pole MICRO anchor accessories. • Always disconnect the 12 Volt power source from the anchor before servicing. • Do not use your Power-Pole MICRO anchor as a form of assistance when entering or exiting the vessel. -
Page 18: Two (2) Year Limited Warranty
1. Power-Pole MICRO shallow water anchor warranties are activated upon receipt by JL Marine Systems, Inc. of the completed warranty card, postdated within (10) days of the original purchase date or by registering your Power-Pole on our website. Please retain your sales receipt as proof of purchase. - Page 19 (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. MICRO Installation & Owner’s Guide 2018 | www.power-pole.com | 19...
- Page 20 Do not use the Power-Pole shallow water anchor as your primary anchorage. 813.689.9932 option 2 Never leave your boat unattended while anchored solely with the Power-Pole shallow water anchor. Need help? Contact our Technical Support Team at 1 + 813.689.9932 option 2...
Need help?
Do you have a question about the Micro Anchor and is the answer not in the manual?
Questions and answers