Figure 4-3 [Change Capacity] Window (Updated) - Hitachi LQE550 User Manual

4 OPERATION
③ Defaults
Transfer areas: None (Receiving only)
Hold/clear: Clear
(You can either "hold" or "clear" the associated G-register area when a reception
timeout is detected. For details, see under "(4) Reception timeout" in
"5.1 Transfer Cycle.")
To change the settings, follow these instructions:
• To set a transfer area
Uncheck the "Receiving only" check box by clicking it and enter the starting address and
the ending address into the left-side and right-side boxes of the transfer area, respectively.
The G-register area (G000 to GFFF) is used for transfer. Enter the start address and end
address values that are within the range of /000 to /FFF.
For details on the number and range of transfer words, see "5.1 Transfer Cycle."
• To change the clear/hold setting to "Hold"
Click the [Hold] radio button.
Figure 4-3 shows a sample transfer area setting of G100 to G1FF, with a clear/hold setting
of "Hold."
④ Click the OK
The setup is now completed.

Figure 4-3 [Change capacity] Window (Updated)

button.
Transfer area setup changed here
Clear/Hold setting changed here
4-6