Dispensing Coffee - Whirlpool 8LCH-KKSCSSS5HW User Manual

DISPENSING COFFEE

Operating Instructions:
1. Make sure the RED hot water switch at the back of the unit is on (See #15 on page
11).
PRE-
INFU-
HEAT/
SION
READY
Touch the PRE-HEAT/READY
2.
button if the LED light is not on.
PRE-
INFU-
HEAT/
SION
READY
3.
PRE-
INFU-
HEAT/
SION
READY
c. If the brewer was switched off, wait up to 10 minutes for the "READY" light to
4.
turn ON. If the "READY" light is flashing, this indicates that there is not enough wa-
ter in the cooler. Wait until water is pumped up. Check if the bottle has water.
5.
PRE-
INFU-
HEAT/
SION
READY
By default, the 8 oz, middle cup
is selected. If you wish a differ-
ent cup size, touch the 4, 6, 8,
10 or 12 oz cup sizes symbol-
ized by the progressively larger
cup images.
PRE-
HEAT/
READY
START
Do not open the lid when the red "do
not open" symbol button is on.
The PRE-HEAT/READY symbol button will
go on only when the hot water temperature is
201°F. The water temperature goes down to
172°F if the brewer is not used for 2 hours. The
ready light might keep on flashing if the water
START
level is low. Please check the bottle.
a. When the "
button is flashing, open the lid
and place a coffee capsule in
the appropriate location inside
the unit
b. Press the capsule down
START
with your hand to pierce the
bottom.
6.
START
INFU-
SION
START
" symbol
Place a coffee cup on top of
the brewer's drip tray.
13