Falcon Handpiece Setup - Chattanooga Intellect RPW 2 Quick Start Manual

I N T E L E C T R P W 2 Q U I C K S TA RT G U I D E
®

FALCON HANDPIECE SETUP

1. Unscrew the shaft from the handpiece and pull it out
of the handpiece handle. Use the supplied open-end
spanner for this purpose.
2. Insert the new projectile into the fitted guiding tube
20
3. Screw the shaft into the handpiece until
finger-tight. Using one hand, press the handpiece
firmly onto the table and tighten the shaft using the
open-end spanner. It must no longer be possible to
unscrew the shaft by hand.
4. Screw the transmitter screw cap with the required
transmitter firmly back onto the shaft. For two-part
transmitter caps: Make sure that the two cap parts are
screwed firmly in place and that the transmitter screw
cap is screwed firmly to the shaft.
5. Connect the Falcon handpiece to the right connector
on the device