Whirlpool 8LIECH-SCSSFP5W User Manual page 13

2. Fill the bottle with the water and bleach mixture.
3. Insert the probe into the bottle.
4. Slide the bottle into the cabinet and close the door.
WARNING
Electrical shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
5. Plug the power cord into a grounded wall outlet.
6. Turn the energy saving switches ON.
7. Allow the water and bleach mixture to fill up the empty reservoirs.
8. Wait 10 minutes then turn the energy saving switches OFF and unplug the power cord.
9. Dispense 1 cup of the water/bleach solution through each tap to clean out the waterways.
10. Place a 2 gallon or larger bucket under the drain plug in the rear of the dispenser.
11. Remove the drain cap and the drain plug. Cold water will immediately flow into the bucket. After several
seconds, hot water will dispense.
Reminder - place the drain cap and the drain plug in a safe location so that they will not be lost.
12. Once the unit has been drained, replace the drain plug and the drain cap.
13. Remove the remaining water from the reservoir by dispensing from the cold tap into a pitcher.
Step D: Rinse Reservoirs
1. Dispose of the water and bleach mixture and rinse the bottle with tap water.
2. Fill the bottle with tap water and insert the probe into the bottle.
3. Push the probe down until it is seated.
4. Slide the bottle into the cabinet and close the door.
WARNING
Excessive Weight Hazard
Use two or more people to move and install bottles.
Failure to do so can result in back or other injury.
5. Plug the power cord into a grounded wall outlet.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-844-494-4757 for assistance.
Model # 8LIECH-SCSSFP5W: Page 13
WARNING
Electrical shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.