Proper Care & Cleaning - Whirlpool 8LIECH-SCSSFP5W User Manual

There may be a small amount of water left in the bottle. This is normal.
1. Open door and slide bottle out.
2. Remove the probe from the bottle:
• Pull the probe straight up until completely out of bottle.
3. Install fresh bottle:
WARNING
Excessive Weight Hazard
Use two or more people to move and install bottles.
Failure to do so can result in back or other injury.
• Place the fresh bottle in front of the tray.
• Clean the fresh bottle using a soft cloth and warm soapy water and then rinse.
• Remove the entire plastic cap from the top of the bottle.
• Insert the probe into bottle.
• Push the probe down until it is seated.
• Slide the bottle onto the tray and close the door completely.
PROPER CARE & CLEANING
General Cleaning
Perform: As needed
Time Required: 5 minutes.
Note: Do NOT use abrasive materials or chemical cleaners.
1. Clean cabinet surfaces with a soft cloth and warm soapy water.
2. Wipe dust from back of dispenser to improve efficiency.
3. Remove drip tray assembly by sliding it forward. Remove cover. Place tray and cover in
dishwasher or wipe parts clean with a soft cloth and warm soapy water.
4. Reattach drip tray assembly.
Your Bottom Loading cooler has the following noise emitting functions:
Self-Cleaning pump noise:
1. When a cooler without a display is plugged in, the air pump for an ozone delivery starts to
work and lasts for 12 seconds. After start up. It will work every 4 hours for the same period
of time. Coolers with a display are programmed to have the ozone delivery pump work
every 4 hours starting from 12 o'clock.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-844-494-4757 for assistance.
Model # 8LIECH-SCSSFP5W: Page 11