Set Water Hardness - Monarch Water SOF3000 HE Installer And User Manual

P. SET WATER HARDNESS
- Wait until display changes to Hardness.
- Press Up Button to show Set Hardness with no flashing.
- Use Up Button to set number as determined by your water hardness test.
- Press to confirm setting.
Up to 30 drops
31-35 drops
36-40 drops
41-45 drops
46-50 drops
- You have finished the programming.
- The display will now automatically revert back to the alternating display.
- If at any time you need to reset any figure, wait until the display changes to the relevant setting
and then re-programme as required.
Q. FLUSH SOFTENER - IMPORTANT
- Place Rapid-Fit bypass in Service position by pushing plunger as per directional arrow - see Fig
A and B on next page.
- Check for leaks.
- Leave a soft mains tap e.g. bathroom wash hand basin, to run for a minimum of 5 minutes to
purge any air and 'resin dust' from the softener (resin dust may appear orange in colour).
- Fill the softener with Tablet salt only (we recommend Monarch Ultimate tablet salt, Pic E),
2-3" below the height of the overflow.
set its own level of water in the cabinet during the automatic regeneration.
- Add 2 litres of water to the salt tank on initial installation only.
If at any time you see excess water in the salt tank, please call our service department on
01986 784759.
6
MONARCHWATER.CO.UK
advance electronic display to 30 (rec min setting)
advance electronic display to 35
advance electronic display to 40
advance electronic display to 45
advance electronic display to 50
The water softener is a 'wet salt softener' therefore will
Pic. E
01986 784759 INFO@MONARCHWATER.CO.UK
to