GE DigitalFlow DF868 Service Manual page 65

GE
Sensing
We,
declare under our sole responsibility that the
DigitalFlow™ GC868 Clamp-On Gas Ultrasonic Flowmeter
DigitalFlow™ GF868 Flare Gas Mass Ultrasonic Flowmeter
DigitalFlow™ GM868 General-Purpose Gas Ultrasonic Flowmeter
to which this declaration relates, are in conformity with the following standards:
• EN 60079-0: 2007
• EN 60079-1: 2004
• EN50281-1-1: 1998
• II 2 G EEx d IIC T6: ISSeP03ATEX113 (ISSeP, B7340 Colfontaine, Belgium - NoBo 492)
• EN 61326-1: 2006, Class A, Table 2, Industrial Locations
• EN 61326-2-3: 2006
• EN 61010-1: 2012, Overvoltage Category II
Other standards Used:
• EN 50014: 1997 +A1, A2
• EN 50018: 2000 +A1
following the provisions of the 2004/108/EC EMC, 2006/95/EC Low Voltage and 94/9/EC ATEX Directives.
Where products were initially assessed for compliance with the Essential Health and Safety Requirements of the
ATEX Directive 94/9/EC using earlier harmonized standards, a subsequent review has determined that "technical
knowledge" is unaffected by the current harmonized standards listed above.
The unit listed above and any ancillary equipment supplied with it do not bear CE marking for the Pressure
Equipment Directive, as they are supplied in accordance with Article 3, Section 3 (sound engineering practices and
codes of good workmanship) of the Pressure Equipment Directive 97/23/EC for DN<25.
Billerica - October 31, 2013
Issued
1100 Technology Park Drive
Billerica, MA 01821
DigitalFlow™ DF8688 Liquid Ultrasonic Flowmeter
DigitalFlow™ GS868 Steam Mass Ultrasonic Flowmeter
GE Sensing
USA
Certification & Standards, Lead Engineer
EC DECLARATION
OF
CONFORMITY
DOC-0013, Rev. B
Mr. Gary Kozinski