Chapter 3. Diagnostics
3.1 Introduction
This chapter explains how to troubleshoot the Model DF868 if problems arise with the electronics console, the
flowcell, or the transducers. Indications of a possible problem include:
•
display of an error message on the active display screen
•
erratic flow readings
•
readings of doubtful accuracy (i.e., readings that are not consistent with readings from another flow measuring
device connected to the same process).
If any of the above conditions occurs, proceed with the instructions presented in this chapter.
3.2 Displaying Diagnostic Parameters
The Model DF868 has a built-in Diagnostics Menu to aid in the troubleshooting of flowcell, transducer and/or
electrical problems. The Diagnostics Menu may only be entered from the Big or Dual measurement mode display. See
Chapter 2, Displaying Data, in the Programming Manual for instructions on setting the display screen to the desired
format, and enter the Diagnostics Menu as shown below.
(Ch1)
label
Velocity Ft/s
6.95
(error codes appear here)
CH1
CH2
SUM
Note: For a 1-Channel Model DF868, the above prompt does not appear, and the following prompt is the initial
screen.
(Ch1)
label
Velocity Ft/s
6.95
(error codes appear here)
TIME
DIAG
Note: Ch1 (or Ch2), which is shown in parentheses above, appears in the locator bar only with a 2-Channel Model
DF868.
DigitalFlow™ Multipurpose Ultrasonic Liquid Flowmeter Service Manual
Press the [
SITE
bar. Press the appropriate
DIF
Press the [
SITE
appropriate
or [
keys until the desired channel option appears on the option
]
]
[Fx]
key to select this option.
DIAG
or [
keys until
]
]
[Fx]
key to select this option.
appears on the option bar. Press the
Chapter 3. Diagnostics
21