Xerox B205 Service Manual page 127

Replacement
1. Begin by aligning the bracket to the mounting screw holes in the lower scanner frame,
then dress the harness back into the lower scanner frame harness guides,
Figure 4 Bracket and harness alignment
2. Replace the screw on the right, first, then properly route and attach the ground wire to the
bracket with the left screw, Figure 5.
NOTE: Ensure the bracket is correctly in-place within the lower scanner frame as shown
in Figure 6.The slot in the bracket near the ground screw and the tab near the opposing
screw must be aligned and inserted correctly before tightening the screws to avoid dam-
age.
Figure 5 Bracket replacement
Repairs / Adjustments
REP 7.1
3. Ensure the harnesses and bracket are routed as shown in,
Figure 4.
Continue the replacement in the reverse of the removal procedure.
July 2019
4-60
Figure 6.
Figure 6 Harness routing
Xerox® B205/B215 Multifunction Printer Service Manual
Initial Release