Copying Tape (Tape Dubbing) - Kenwood XD Series Instruction Manual

Copying tape
The contents of the tape in deck A can be copied onto the
tape in deck B.
The DOLBY NR key is not active in dubbing mode. The tape recorded on deck B assumes the same Dolby NR condition as the tape played on
deck A.
Note Note
Downloaded from: http://www.usersmanualguide.com/
(Tape dubbing)
1 Select the "TAPE" input.
2 Select "[" (double-side recording)
or """ (one-side recording).
REV.M ODE
3 Press the DUBBING key.
4 Select "TAPE DUBBING" and press
the SET key.
1. Select. 2. Press SET.
M ULTI
CON TROL
SET
5 Use the same tape transport direc-
tions.
(1) Select the transport direction of
deck A.
1. Select. 2. Press SET.
M ULTI
CON TROL
SET
(2) Select the transport direction of
deck B.
M ULTI
CON TROL
6 Start dubbing.
EN TER
Load tapes in the decks.
A
Playing tape
CD RECORD
CD EDIT
CD PGM RECORD
TAPE DUBBING
T
÷ When recording is started, the tape w ill be transported in the direction
selected in this step.
Check the tape transport direction
indicators.
A DIR FWD
A
A DIR RVS
B DIR FWD
B DIR RVS
RETURN
÷ By selecting " RETURN" and pressing the ENTER key, the operation
returns to the previous step so the current step can be restarted.
÷ Dubbing ends automatically w hen the side(s) to be dubbed has been
completed.
To stop dubbing
REC/ ARM
÷ The deck B w ill stop after creating a non-recorded portion of about
4 sec, and then the deck A w ill stop.
÷ Dubbing can also be stopped by pressing the stop ( 7 ) key. Note that
the non-recorded space is not created in this case.
Let's record
XD-SERIES (En)
A
Recording tape
A P E D U B B I
| Scrolled display
(TAPE DUBBING)
D I R F W D
33