Advertisement
3. Device Server SX-2000WG+ Setup
(1) Please connect SX-2000WG+ and the PC with one of the following methods:
(a) Prepare a network cross over cable to connect SX-2000WG+ and PC
(b) Prepare two network straight cables and an Ethernet hub to connect SX-2000WG+
and PC
(2) Reset SX-2000WG+ as shown below
(a) Hold pressing the
reset button
(b) Plug the power cable
All Rights Reserved. Copyright © 2008, Hitachi Software Engineering Co., Ltd.
Connect cross over network
cable to SX2000WG+ and PC
(a) Connect straight network cable to
Ethernet hub and PC
(b) Connect straight network cable to
Ethernet hub and SX-2000WG+
(c) Hold pressing the button until the LED
turns red, then release the button.
3
Advertisement
