Operations - Yamaha 485RDS Owner's Manual

2
TO PLAY A SOURCE
1
Set to the "
2
3
Select a desired input source.
RX-485 RDS
MONITOR
TAPE 2 TAPE 1 AUX
COPY
RX-385, RX-385 RDS
TAPE
MONITOR AUX
* The name of the selected input source will appear in the
display.
* Note that pressing on each input selector button selects
the source which is connected to the corresponding input
terminals on the rear panel.

OPERATIONS

4
VOLUME
0
— dB
∞
" position.
POWER
INPUT
TUNER CD PHONO
INPUT
TUNER CD PHONO
3
7
4
Select the speakers to be used.
* If you use two speaker systems, press both the A and B
switches.
5
Play the source. (For detailed information on the tuning
operations, refer to the page 12.)
6
Adjust to the desired output level.
7
If desired, adjust the BASS, TREBLE, BALANCE and
LOUDNESS controls, etc. (Refer to page 11.)
Notes
RX-485 RDS only
If you select AUX, TUNER, CD or PHONO, be sure that
TAPE 1 and/or TAPE 2 are not being selected.
If you select TAPE 1 and TAPE 2 at the same time, the
result will be the sound from the tape deck 1.
For TAPE 1 and TAPE 2, whenever the button is pressed,
the corresponding input source is selected or canceled
alternately.
RX-385 and RX-385 RDS only
If both TAPE MONITOR and another input selector button
are selected, TAPE MONITOR has priority.
1, 6
SPEAKERS
A B
ON
ON
OFF
OFF
VOLUME
0
— dB
9