Yamaha 485RDS Owner's Manual page 19

Calling a preset RDS station by the program type (PTY SEEK)
By designating a program type, the unit automatically searches all preset stations for RDS stations of that program type.
* There are 15 program types to classify RDS stations. For details, refer to page 16.
1
Turn the unit into the PTY mode.
PS/PTY SEEK
FREQ/PS/PTY SHIFT ENTER
* If "NO PTY" flashes, proceed to the next step while
flashing. If "NO PTY" disappears before you proceed to the
next step, press the FREQ/PS/PTY button once or twice.
2
PS/PTY SEEK
FREQ/PS/PTY SHIFT ENTER
The program type of the station now being
received or "NEWS" flashes on the display.
3
Select the desired program type.
TUNING
DOWN
* By pressing the TUNING button repeatedly or by pressing
and holding it, the display will change program types in
sequence.
3 5
Press once or twice until a
program type is displayed
or "NO PTY" flashes.
UP
4
When the desired program type appears, press the
ENTER button.
PS/PTY SEEK
FREQ/PS/PTY SHIFT ENTER
5
PRESET
STATIONS
DOWN UP
The unit begins searching all preset stations, and calls a
station of the program type if such a station is found.
* When the right side of the PRESET STATIONS button is
pressed, the search is performed from "A1" toward higher
numbers of the preset stations (A1, A2 ... A8, B1, B2, ...).
If, however, "A3" is currently being called for example, the
search begins from the next station "A4".
When the left side of the PRESET STATIONS button is
pressed, the search is performed in reverse order.
If the called station is not the desired one, press the
PRESET STATIONS button again to search for another
station of the same program type.
To cancel this function
Press the AF, FREQ/PS/PTY, SHIFT, ENTER, FM/AM or
MEMORY button.
Note
If no station is found by this function, after searching all preset
stations, "NO PTY" flashes for about 3 seconds on the
display, and then it returns to the mode which had been
obtained before the searching was performed.
1, 2, 4
ENTER
Flashes.
Press once.
19