Reinstall Controller Canister - Fujitsu ETERNUS AB Series Hardware Maintenance Manual

4. Hand-tighten the HIC thumbscrew.
Do not use a screwdriver, or you might over tighten the screws.
5. Using a #1 Phillips screwdriver, attach the HIC faceplate you removed from the original HIC with the three
screws.
What to do next
Go to

Reinstall controller canister

Reinstall controller canister
After replacing the host interface card (HIC), you reinstall the controller canister into the controller shelf.
Procedure
1. Lower the cover on the controller canister and secure the thumbscrew.
2. While squeezing the controller handles, gently slide the controller canister all the way into the controller
shelf.
Note: The controller audibly clicks when correctly installed into the shelf.
3. Install the SFPs from the original controller in the host ports on the new controller, and reconnect all the
cables.
If you are using more than one host protocol, be sure to install the SFPs in the correct host ports.
| Host interface cards |
59