Display Assembly - HP ProBook 450 G8 Maintenance And Service Manual

4. Remove the power connector cable from the computer (5).
Reverse this procedure to install the power connector cable.

Display assembly

To remove and disassemble the display assembly, use these procedures and illustrations.
Full hinge-up displays are not available as spare parts. Spare parts for displays are available only at the
subcomponent level.
Before removing the display panel, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Disconnect the battery cable from the system board (see
4. Remove the power connector cable
Remove the display assembly:
1. If you need to remove the bezel:
a. Flex the top (1), the left and right sides (2), and then the bottom of the bezel (3) to release it.
b. Remove the bezel from the display (4).
The display bezel is available as the following spare part numbers:
M21991-001: Models without a camera
M21992-001: Models with an HD camera
M21993-001:Models with an HD + IR camera
50 Chapter 5 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
(Bottom cover on page 30).
(Power connector cable on page
30).
Battery on page 31).
49).