Post-Installation Check - Huawei NetCol8000-E220 Series Quick Manual

(Optional) Connecting T/H Sensors Outside Cabinets
6.2
The following figure shows the position of the
return air temperature and humidity sensor in
the smart cooling product. The cable passes
through the cable hole to remote T/H sensor.
Set the sensor positions based on their location
and the following table.
1. Connect the T/H sensor cables.
After the addresses are set, power on the
device. On the display's home screen, choose
Settings > System Settings > T/H Sensor, and
set the sensors in the aisles corresponding to
the addresses to Enable. Otherwise, the
sensors will not work.
2. Set the DIP switches on the T/H sensors.
Name
Cold aisle 1 temp/humid
Cold aisle 2 temp/humid
Cold aisle 3 temp/humid
Cold aisle 4 temp/humid
Cold aisle 5 temp/humid
Hot aisle 1 temp/humid
Hot aisle 2 temp/humid
Hot aisle 3 temp/humid
Hot aisle 4 temp/humid
Hot aisle 5 temp/humid
(Optional) Connecting Teamwork Network Cable and Monitoring Cable
6.3
(1) FE_1 (input and output port on the FE ring network)
(2) CAN_IN (input port of the teamwork CAN/northbound
RS485 port)
(3) RS485/12 V (T/H module port)
(4) USB (USB port)
(5) DP (connected to the display port)
(6) COM/FE (northbound RS485 port)
8

Post-Installation Check

(7) CAN_OUT (output port of the teamwork CAN/northbound
RS485 port)
(8) FE_2 (input and output port on the FE ring network)
(9) SW (for restoring factory settings)
(10) Alarm indicator
(11) Run indicator
Address
1
11 ON
12 OFF
13 ON
14 OFF
15 ON
21 ON
22 OFF
23 ON
OFF
24
ON
25
13
DIP Switch ID
2 3
ON OFF ON
OFF ON ON
OFF ON ON
ON ON ON
ON ON ON
OFF ON OFF
ON ON OFF
ON ON OFF
OFF OFF ON
OFF OFF ON
4 5 6
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
ON OFF
ON OFF
ON OFF
ON OFF
ON OFF