Step Sequencer Midi Output - Yamaha AN1x Owner's Manual

Control synthesizer analog physical modeling
Hide thumbs Also See for AN1x:
Table of Contents

Advertisement

Storing Step Sequences
Depending on whether the Step Sequencer is in Single
Pattern Play or Pattern Select Play status, you can do the
following:
Perform a Voice Store operation to store the current Voice
Pattern data in the Voice edit buffer as voice data (in
Single Pattern Play status).
For information about performing a Voice Store operation, see page 98.
Perform a Sequence Store operation to store the currently
selected pattern to any User Pattern memory (in Single
Pattern Play or Pattern Select Play status).
SEQ Store Operation
Knob
Pattern
Event
1-8 / 9 -16
Step Hold
Bank
No
Base Unit
1. Press SEQ Store [UP/DOWN] to select the user
pattern location. "SURE? [Y/N]" and "Bank
User" flash alternately in the LCD.
2. Press [YES/ENTER] to store the pattern, or [NO]
to cancel the operation
The SEQ Store operation temporarily stores the pattern currently playing to the
pattern edit buffer, so be sure to perform a Voice Store operation (see page 98)
before selecting another voice.
SEQ
SEQ
Length
LoopType
Ctrl No
Store
EDIT /SETUP
46
Step Sequencer MIDI
Output
You can use the MIDI Pattern Transmit Channel ("PtnTxCh")
parameter to designate a MIDI channel on which to output
the Step Sequencer pattern data, to either play an external
tone generator or record the data into a MIDI sequencer or
computer.
Common
Arp /SEQ
Type/No
KbdMode
Hold
SceneSw
This setting is independent from the MIDI Transmit Channel
("MIDI Tx Ch") in the UTILITY SETUP menu (see page 93),
but you can either set them both to the same channel or
different channels, depending on your requirements. The
diagram below shows an example of how they can be set
to different channels to control two different external tone
generators.
Ext. TG 2
Ext. TG 1
(Attack sound)
(Pad sound)
Rcv. Ch2
Rcv. Ch1
Ptn TxCh2
MIDI TxCh1
Step
Sequencer
(Depends on Keyboard Mode setting)
For information about setting the MIDI Pattern Transmit Channel ("MIDI
PtnTxCh"), see page 87.
The MIDI PtnTxCh setting is a system parameter, and will not be saved as voice
data.
MIDI
Arpeggio
Play EF
VOICE
Ptn Tx Ch
Subdivide
Swing
Velocity
GateTime
ARPEGGIO / SEQ

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents