Mitsubishi Electric 800 Series Instruction Manual page 48

 PZD
Name

Control enable

Fault reset
(Reset)


STW
PZD enable
STF signal
STR signal
RT signal
MRS signal
RAM/EEPROM
Bit
0 to 2 Not used (1 is set)
3 0: Inverter output shutoff, 1: Inverter output shutoff is cancelled
4 to 6 Not used (1 is set)
[At inverter error]
0: No action
1: Fault reset (Reset).
7
The operation depends on the Pr.349 setting. (Refer to
[When inverter is normal]
No action
8 Not used (0 is set)
9 Not used (0 is set)
0: Command request of PZD is not processed.
10
1: Command request of PZD is processed.
At power-on or inverter reset, set 1 once.
11 0: OFF, 1: ON (forward rotation command)
12 0: OFF, 1: ON (reverse rotation command)
13 Second function selection
14 0: OFF, 1: ON (output is shut off)
0: Set frequency (HSW) is written to RAM (Power-on reset returns the changed
15 set frequency to the setting before it was written to RAM.).
1: Set frequency (HSW) is written to EEPROM.
Definition
*1
PPO TYPE SUPPORT SPECIFICATION
page 34.)
47
7