Philips InnoSpire Go Faq page 3

Q. How many charge/discharge cycles can it do?
A. InnoSpire Go is life tested for 234 charge/discharge cycles. This is based on having to charge the
device once a week for three years.
Q. Can I charge the device and take a treatment at the same time?
A. Yes, you can.
Q. What is the recommended charging procedure? Do I need to wait until it's fully discharged?
A. You do not need to wait for the battery low indicator before you can charge the device. Frequent
charging is beneficial to the life of the battery. However it is not recommended to leave the device
on charge once the battery is full.
Q. What is the lifetime rating for the InnoSpire Go battery?
A. The design life is three years.
Q. Will I see any changes in treatment as the battery starts to approach the end of its three-year
design life?
A. There may be a reduction in the number of treatments you will get from one charge, but this will
be minimal.
Technical specifications
Q. What is the size of the InnoSpire Go?
A .7.0cm x 4.5cm x 13.5cm
Q. What is the weight of the InnoSpire Go?
A. 0.29 lbs/111g
Q. What is the overall weight and size of the InnoSpire Go packed into its carry case with
consumables?
A. The size is approximately 164mm x 70mm x 220mm and the weight is approximately 497 grams.
Q. What is the noise level?
A. Less than 35dB
Q What is InnoSpire Go made of?
A. The mesh, (which is inside the mouthpiece assembly) is nickel palladium and the outer body is
made of a plastic material.
Q. Is InnoSpire Go BPA free?
A. Yes. The InnoSpire Go nebulizer is BPA free.
Cleaning and maintenance
Q. Do I need to disassemble the mouthpiece for cleaning?
A. No. The mouthpiece is only one part, it should be released from the handset for cleaning.
Q. Can the mouthpiece assembly be disinfected? If so, How?
A. Yes. There are three ways you can disinfect the mouthpiece assembly which are boiling, steaming
and immersion in a Korsolex® disinfectant solution. Please refer to the instructions for use for
details.
3