Philips Respironics Wisp Youth Instructions For Use Manual

Instructions for Use
Wisp Nasal Mask

Intended Use

The Wisp Youth Nasal Mask is intended to provide an interface for application of CPAP or bi-level
therapy to patients. The mask is for single patient use in the home or multi-patient use in the hospital/
institutional environment. The mask is to be used on patients 7 years or older (>40 lbs/18kg) for whom
CPAP or bi-level therapy has been prescribed.
The Wisp Nasal Mask is intended to provide an interface for application of CPAP or bi-level therapy to
patients. The mask is for single patient use in the home or multi-patient use in the hospital/institutional
environment. The mask is to be used on patients (>66lbs/30kg) for whom CPAP or bi-level therapy has
been prescribed.
Notes:
• Exhalation is built into this mask so a separate exhalation device is not required.
• This mask is not made with natural rubber latex or DEHP.
Caution: U.S. Federal law restricts this device to sale by or on the order of a physician.
Symbols
Warning or Caution
Not Made with Natural Rubber Latex
Warnings
• This mask is not suitable for providing life support ventilation.
• Hand wash prior to use. Inspect the mask for damage or wear (cracking, crazing, tears, etc). Discard and
replace any components as necessary.
• Some users may experience skin redness, irritation, or discomfort. If this happens, discontinue use and
contact your healthcare professional.
• Consult a physician or dentist if you encounter tooth, gum, or jaw soreness. Use of a mask may
aggravate an existing dental condition.
• Consult a physician if you experience the following symptoms while using the mask or after removing
it: Drying of the eyes, eye pain, eye infections, or blurred vision. Consult an ophthalmologist if
symptoms persist.
• The mask material should be away from your eyes.
• Do not block or seal off the exhalation ports.
• Do not overtighten the headgear straps. Watch for signs of overtightening, such as excessive
redness, sores, or bulging skin around the edges of the mask. Loosen the headgear straps to alleviate
symptoms.
• This mask is designed for use with CPAP or bi-level systems recommended by your health care
professional or respiratory therapist. Do not wear this mask unless the CPAP or bi-level system is
turned on and operating properly. Do not block or try to seal the exhalation port.
the Warning:
CPAP systems are intended to be used with special masks with connectors which have
vent holes to allow continuous flow of air out of the mask. When the CPAP machine is turned on and
functioning properly, new air from the CPAP machine flushes the exhaled air out through the attached
Note
Tip
X1
System One Resistance Control
1
Explanation of