Introduction; Safety; Assembly; Operation - Husqvarna S 13 Operator's Manual

• This machine is designed for picking up dry, non-
flammable dust and debris in an indoor environment.
It is not suitable for picking up liquids.
• Do not pick up any type of liquids.
• Do not allow a build-up of dust, hair and anything
that may reduce airflow.
• Keep hair, loose clothing, fingers and all parts of
body away from openings and moving parts.
• Use extra care when cleaning on stairs.
• Do not use the product without dust bag and/ or
filters in place. Replace collection system and/or
filters as described in this manual.
• Turn of all controls before unplugging.
Personal protective equipment
WARNING: Read the warning instructions
that follow before you use the product.
• Always use approved personal protective equipment
during operation. Personal protective equipment
does not give you full protection but it decreases the
degree of injury if an accident occur. Speak to you
servicing dealer for recommendations about which
equipment to use.
• Use approved protective gloves when you
maintenance the product.
General
Do a check that the following accessories are included:
• The hose with end fittings
• Steel tube
• Floor Nozzle
• Multi adapter (only S 13/S 26)
If 1 of the parts is missing, speak to your local service
agent or salesman.
For models that do not have the front casters assembled
because of the limit of package:
• Assemble the front casters using the bolt or the nut
and the washer included in the package.
Make sure to dispose the package and the used product
components in correct procedure. Refer to local disposal
regulations. Make sure to recycle.

Introduction

WARNING: Before you operate the product,
carefully read and understand the safety
chapter and the operation instructions.
16
Work area safety
WARNING: Read the warning instructions
that follow before you use the product.
• Do not use outdoors or on wet surface, this product
is for indoor use only.
• Do not expose the product to rain and moisture,
store indoors only.
Safety instructions for maintenance
WARNING: Read the warning instructions
that follow before you use the product.
• Make sure the engine switch is in the Off position.
Disconnect the product from the wall outlet.
• Do not modify the product from its original design.
• All repairs must be performed by a qualified service
person. Use only manufacturer-supplied or
equivalent replacement parts.
• Use approved protective equipment. Refer to
Personal protective equipment on page 16
• Do not make a hole in the HEPA filter. A broken
HEPA filter can disperse dust.

Assembly

To attach the suction hose
There is a hose intake with a hose lock on the product.
The hose lock makes sure that the suction hose adapter
do not fall off.
1. Lift the hose lock and attach the suction hose
adapter.
2. Lower the hose lock into the recess of the adapter.
To attach the nozzle on the hand pipe
The floor nozzle has adjustable wheels. Adjust the
wheels to get the best suction effect. Adjust the wheels
with the knob, which is on the rear side of the nozzle.
The wheels and rubber strips of the nozzle can be
replaced. Keep the nozzle in good condition.

Operation

Before use
WARNING: Before using the dust extractor
make sure that the power and voltage
corresponds with the voltage shown on the
896 - 004 -