Related Manuals for Ingenico group Lane/8000
Summary of Contents for Ingenico group Lane/8000
- Page 1 Lane/8000 User Guide www.ingenico.com 28-32, boulevard de Grenelle, 75015 Paris - France / (T) +33 (0)1 58 01 80 00 / (F) +33 (0)1 58 01 91 35 Ingenico - SA au capital de 47 656 332 / 317 218 758 RCS Nanterre...
-
Page 2: Table Of Contents
4_Installation & Connections 4_1 Positionning the terminal 4_2 Inserting SAM (Secure access module) and Micro SD 4_3 Connecting the terminal to the host 4_4 Setting the Lane/8000 on the standpole adaptor Lane/8000 Copyright© 2019 Ingenico 900030066 R11 000 02/1219 All rights reserved... - Page 3 6_3 Troubleshooting 7_Norms & Markings 7_1 Information to users in the United States and Canada 7_2 No unauthorized modifications 7_3 Antenna requirement 7_4 Environment (WEEE, Batteries and Packaging) 7_5 Markings Lane/8000 Copyright© 2019 Ingenico 900030066 R11 000 02/1219 All rights reserved...
-
Page 4: 1_Introduction
Failure to comply with these instructions will void the manufacturer’s responsibility. This symbol indicates an important Warning. This symbol indicates a piece of advice. Lane/8000 Copyright© 2019 Ingenico 900030066 R11 000 02/1219 All rights reserved... -
Page 5: 2_Unpacking
The power supply unit provided with your equipment is specially designed for it. Do not use any other power supply. ADVICE Keep the packaging. It must be re-used whenever the terminal is shipped. Lane/8000 Copyright© 2019 Ingenico 900030066 R11 000 02/1219 All rights reserved... -
Page 6: 3_Recommendations
To power on or power down the terminal, connect or disconnect the power supply from the electric outlet. Power supply unit CAUTION Only use the power supply AC/DC provided with Lane/8000 or the power provided by a cash register limited power source (LPS). CAUTION... -
Page 7: 3_2 Security Of Your Terminal (Tampering Attempt Detection)
The terminal must never be put in or left at a location where it could be stolen or replaced by another device. Lane/8000 Copyright© 2019 Ingenico 900030066 R11 000 02/1219 All rights reserved... - Page 8 If the warranty label is torn or removed, the warranty will be void. CAUTION Positioning of the Lane/8000 on check stand must be in such a way to make cardholder PIN (Personal Identification Number) spying infeasible. Installing device on an adjustable stand must be in such a...
-
Page 9: 3_3 Main Characteristics
Ambient temperature from 0°C to +45°C Max relative humidity 85% RH non-condensing at +40°C Max altitude 2000 m Storage conditions Storage temperature -20°C, +55°C Max relative humidity 85% at +55°C Lane/8000 Copyright© 2019 Ingenico 900030066 R11 000 02/1219 All rights reserved... -
Page 10: 3_3_2 Power Characteristics
3_3_2 Power characteristics Power supply units The Lane/8000 can be powered by several ways : An external power supply unit By POE (Power over Ethernet) By USB (12VDC) POE (Power over Ethernet) The power sourcing equipment must be compliant with IEEE802.3af standard, class 0 which means 12.95W max. -
Page 11: 3_3_3 Terminal Connectivity
Frequency band ISM band 2400 MHz to 2483.5 MHz Type of modulation GFSK, Pi/4 QPSK, 8 DPSK Number of channels 79 (1 MHz BW) Max output power <4 dBm Lane/8000 Copyright© 2019 Ingenico 900030066 R11 000 02/1219 All rights reserved... -
Page 12: 3_4 Functional Description
7 inch- stripe touchscreen Reader Contactless Reader Keypad Smartcard Reader USB Type second A port Ethernet port (option) (option) Multipoint Connector Speaker Standpole (option) Adaptor pattern 3,5mm Audio Jack (option) Lane/8000 Copyright© 2019 Ingenico 900030066 R11 000 02/1219 All rights reserved... -
Page 13: 4_Installation & Connections
(away from video terminals, PC, anti-shoplifting barriers ...). The terminal is exclusively made for indoor use. The Lane/8000 device may be mounted on a flat surface, wall, or customer stand. CAUTION Do not place the Lane/8000 device on a PC monitor, adjacent to an electronically active security tag deactivation system, or near other sources of magnetic fields. - Page 14 SAM Card is inserted in the correct manner. The cut corner must be positioned as indicated on the figure below. SAM3 SAM2 SAM1 Micro Cut corner Slide back the module and screw them tight Lane/8000 Copyright© 2019 Ingenico 900030066 R11 000 02/1219 All rights reserved...
-
Page 15: 4_3 Connecting The Terminal To The Host
ESD shoes for example. 4_3 Connecting the terminal to the host CAUTION Connecting must be made when power supply unit is not plugged in the cable. Lane/8000 Copyright© 2019 Ingenico 900030066 R11 000 02/1219 All rights reserved... - Page 16 Lane/8000. We advise to check with your reseller their compatibility if you plan to replace an iSC480 / ISC250 / ISC Touch 250 by a Lane/8000. Following are some examples of accessories that can be used to connect the Lane/8000 (ACC-LANE8000). This list is not exhaustive.
-
Page 17: 4_4 Setting The Lane/8000 On The Standpole Adaptor
Reference : 296114829AD (length 2m) Power supply unit 296114829AD (length 2m) Connector for terminal Ethernet connector 4_4 Setting the Lane/8000 on the stand pole adaptor Install the terminal on a flat surface is not possible on the Lane/8000 as is. It is designed to be fitted on a standpole adaptor. - Page 18 To fit the Lane/8000 to the stand pole adaptor, it only requires to slide down the Lane/8000 until a click sound: Click! The Lane/8000 is now ready to use : Lane/8000 Copyright© 2019 Ingenico 900030066 R11 000 02/1219 All rights reserved...
-
Page 19: 5_Daily Use
(at about 1cm). Keep the card close to the contactless logo during the transaction. Your contactless terminal provides four contactless status lights located above the contactless logo. Lane/8000 Copyright© 2019 Ingenico 900030066 R11 000 02/1219 All rights reserved... -
Page 20: 5_2 Signature Capture
This option is not designed to play music, but to facilitate the use by blind people. The jack is 3.5mm, 32 ohms impedance. Lane/8000 Copyright© 2019 Ingenico 900030066 R11 000 02/1219 All rights reserved... -
Page 21: 5_4 Camera (Optional)
The Lane/8000 can be equiped with a module integrating a 5 megapixels autofocus camera. Reference of the module : MODU/8005 WiFi/BT Note : The Lane/8000 can be equipped with a module without camera. Reference of the module : MODU/7003 WiFi/BT Lane/8000 Copyright©... -
Page 22: 6_Maintenance
If you have another working Lane/8000 device, swap the devices to determine if the problem is with the device, cable, POS, or power supply. If the Lane/8000 device is directly connected to a host, reset the host by turning it off and back on again. Lane/8000 Copyright©... - Page 23 Magnetic Card Reader Does Not Work Properly When sliding the card through the reader, make sure that the magnetic stripe on the card is facing the Lane/8000 display screen (see Swiping a Magnetic Stripe Card). Swipe the card at a faster or middle steady speed.
-
Page 24: 7_Norms & Markings
: (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. Lane/8000 Copyright© 2019 Ingenico 900030066 R11 000 02/1219 All rights reserved... - Page 25 être installé et utilisé avec un minimum de 20 cm de distance entre la source de rayonnement et votre corps. Ce transmetteur ne doit pas être placé au même endroit ou utilisé simultanément avec un autre transmetteur ou antenne. Lane/8000 Copyright© 2019 Ingenico 900030066 R11 000 02/1219 All rights reserved...
Need help?
Do you have a question about the Lane/8000 and is the answer not in the manual?
Questions and answers
we need to replace the device and cannot get it off the holster