Step 2 - Mount The Battery Wand, If Applicable - Hunter Douglas Silhouette DuoLite Installation Operation Care

INSTALLATION
STEP 2: PowerView
Battery Wand, If Applicable
For the headrail-mounted battery wand and rechargeable battery wand, battery wand clips
and battery wand/rechargeable battery mount are installed before the shading is installed.
Any other power options, the power source will be connected after the shading is installed.
Battery Wand
Install the Battery Wand Clips
Attach the battery wand clips to the headrail.
■
IMPORTANT: Position the clips close to the power cable.
Mount the Battery Wand into the Battery Wand Clips
Position the battery wand with its socket
■
toward the motor end of the shading.
Push the battery wand straight up into the
■
battery wand clips until it snaps into place.
Check to make sure the battery wand
is secure.
CAUTION: Be sure the cables do not
become pinched by the battery wand clips
during installation. Damage or overheating of
components could result.
Plug the Power Cable into the Battery Wand
NOTE: When power is connected to the motor, a green LED inside the programming button
housing will flash to indicate the shading is ready for operation.
From the back of the shading headrail, connect the power cable (from the motor side) into
■
the socket on the battery wand.
Proceed to "STEP 3: Install the Shading" on page 10.
8
and SoftTouch
®
Only: Mount the
®
toward the motor end.
Power
Cable
Place the socket
Battery
Wand