Page 21
Specifications ���������������������������������37 Cleaning the shaver �����������������������31 Replacing the system outer foil and the inner blades�����������������������32 Thank you for purchasing this Panasonic product. Before operating this unit, please read these instructions completely and save them for future use. ES-LV5A_CH.indb 2016/03/11 10:19:16...
Safety precautions WARNING To reduce the risk of injury, loss of life, electric shock, fire, and damage to property, always observe the ►This product following safety precautions. Do not use the appliance for wet shaving. - Doing so may cause electric shock or fire due to Explanation of symbols a short circuit.
Page 23
WARNING Do not immerse the AC adaptor in water or wash with water. Do not place the AC adaptor over or near The supply cord cannot be replaced. If the cord water filled sink or bathtub. is damaged, the AC adaptor should be scrapped. Never use the appliance if the AC adaptor is - Failure to do so may cause an accident or injury.
Page 24
WARNING CAUTION Disconnect the AC adaptor when cleaning the ►Protecting the skin shaver with water. Do not use excessive pressure to apply the - Failure to do so may cause electric shock or injury. system outer foil to your lip or other part of Regularly clean the power plug and the appliance your face.
Page 25
CAUTION Handling of the removed battery when disposing DANGER ►Note the following precautions Do not wrap the cord around the adaptor The rechargeable battery is exclusively for when storing. use with this appliance. Do not use the battery - Doing so may cause the wire in the cord to with other products.
Intended use WARNING • Do not bring the system outer foil into contact with After removing the rechargeable battery, do not hard object. keep it within reach of children and infants. Doing so may damage the blades as they are very - The battery will harm the body if accidentally thin and deform easily.
How to use While charging After charging is completed Shaving beard Press and shave. • The “shaving sensor”, which glows. The battery capacity automatically adjusts the power The number of the battery lamp and will light up depending on the beard thickness, will capacity lamp will increase and then turn off after operate.
Page 29
• To prevent damaging the system Notes • The appliance may not operate in an ambient outer foil, do not shave with only a part of the system outer foil. temperature lower than approximately 5 °C. • Depending on the beard thickness or the amount of beard trimmings in the shaver head, the shaving sensor may not react and the driving sound may not Press...
Page 30
►Cord shaving Locking/unlocking the power switch If you insert the appliance plug to the shaver and plug Locking the power switch the adaptor into a household outlet, you can use it even if the battery capacity is low. 1. Press once 2.
• After about 20 seconds, it will be automatically Tips for better usage Apply the trimmer edge perpendicular to skin and move turned off, or you can turn it off by pressing the downward. power switch. Trimming sideburns Pre‑shave of long beards Remove the outer foil section and clean with running water.
Page 32
►Cleaning with the short brush The mark on the left means suitable for • Clean the inner blades using cleaning under an open water tap. the short brush by moving it in direction as illustrated. Warning • Do not move the short brush Disconnect the cord from the shaver before perpendicularly against the cleaning it in water to prevent electric shock.
►Replacing the system outer foil 1. Press the system outer foil release buttons and pull down the system Question Answer outer foil. The battery will deteriorate if 2. Align the foil frame mark ( ) and the Will the battery not used for over 6 months, system outer foil mark ( ) and deteriorate if not used...
If the problems still cannot be solved, contact the When the shaver is extremely store where you purchased the unit or a service dirty, remove the foil frame center authorized by Panasonic for repair. and wash with water. (See page 31.) The shaving sensor...
Page 35
Problem Action Problem Action The shaving sensor is Apply oil. The driving sound operating. The sound System outer foil gets Replace the system outer foil changes while shaving. changes depending on the hot. if it is damaged or deformed. beard thickness. (See page 33.) Apply oil.
• Perform steps 1 to 5 and lift the battery, and then Battery life remove it. • Take care not to short circuit the positive and negative The life of the battery is 3 years. The battery in this shaver terminals of the removed battery, and insulate the is not intended to be replaced by consumers.
Specifications Product name AC/Rechargeable Shaver ES ‑ LV5A Product model 100‑240 V 50‑60 Hz Rated input 180 mA Rated output 4.8 V 1.25 A Charging time Approx. 1 hour Main body: Japan Place of origin AC adaptor: China See engraving on the Date of production commodity.